0 Item Items
This product is no longer in stock
Warning: Last items in stock!
Availability date: 01/01/0100
Main rotor diameter: 240mm
tail rotor diameter: 36mm
motor pinion gear: 9T
Main Drive Gear: 61T
Flying Weight: 48g
5 in 1 receiver board C; 3.7V 240mah LI-PO battery x 3pcs; N40 brushed motor; tail motor; 2g servo(5 lines)x3; USB charger cable; 3P charger wire ; special screw driver.
1. All signal wire connectors must be connected correct as required, otherwise will result failure of receiving remote signal, even receiver burnt and so on serious consequences.
2. To avoid the knob broken, it needs to use the special configured adjust pen when adjusting all knobs.
3. When code-pairing, helicopter must be satic placed horizontal position.
4. When boot should follow the principle of ¡°turn on the transmitter first then power on the plane¡±. After turn on the transmitter, power on the plane within 10 seconds, receiver¡¯s indicator light start flashing slow about 1~3 seconds, which means it is receiving the signal.If the light not on, it means receiving no signal, code-pairing is needed. Indicator light flash fast after receiving signal, which means the gyro is initializing. If the red light turn to constant light, and sound the mechanical voice of servo reset, which means the receiver start to work.
The transmitter used to flying( need pay for it ):